The difference between spicy wood and spicy wood used Spicy wood is gray or dark compared to green wood. The inside of the wood is white and has many small cracks on the inner ring and becomes very brittle. Unseasoned wood is damp and looks very new and fresh in the middle.
When burning waste wood, water vapor enters the chimney along with other gases and particles, and if the chimney is not kept warm, the condensate forms creosote, which solidifies when heated and forms tar in the chimney. A chimney fire can be a real risk if too much tar builds up in a chimney.
Simply put, it means that the wood has been seasoned, it has been dried for a long time, which allowed the moisture of the wood cells and the sap to evaporate from the wood. Spiced wood is different from green wood and kiln dried wood.
Unspun wood means wood that has not yet dried to a humidity level compatible with the expected environment (this could be 12% for interior floors in Victoria and around 16% for exterior terraces in Victoria. June in Victoria ).
Ideally, the wood remains uncovered so that it can dry properly. However, this is not practical when rain, snow and ice can quickly cover the winter forest. A good blanket on your pile will protect it and ensure the blanket is tilted to wick moisture away from the batteries.
Check the ends of the logs to identify wood that has aged. If they are dark and cracked, they are dry. Spicy dry wood is lighter than wet wood and makes a dull sound when two pieces are struck together. If a green color is visible or if the bark is difficult to peel, the trunk is not yet dry.
Freshly cut wood contains up to 80 percent moisture and must be seasoned on the inside before burning, i.e. dried to a moisture content of 2025 percent. Since your trees are already ■■■■, the seasoning process has already begun and the wood should be dry enough to burn less time.
Technically, you can burn a piece of wood a few minutes after it is cut, but it will be difficult to light the fire and keep it burning if the wood is green. You should let the wood sit and dry for a while after cutting for best lighting results.
- Remove branches from downed trees with a machete, chainsaw, or chainsaw.
- Leave the tree exposed so the wind and sun can dry it faster.
- Bring the wood stock a day or two before you need to burn it.
- Find the wood when you come to the camp.
about 6 months
Over time, most of the treated wood will shrink slightly in width as it dries. Watch out for this small indentation when laying patios or fence boards. After six to twelve months outdoors, treated wood will develop cracks on the surface of each plank known as checks.
Strength classes: F and MGP
Wood F5 and F7
Shrinkage and swelling occur when wood changes its moisture content in response to diurnal and seasonal changes in the relative humidity of the atmosphere; H. in humid air wood absorbs moisture and swells in dry air, wood loses moisture and shrinks.
Shrinkage is the reduction in the size of the wood due to the movement of moisture from the cell walls of the wood. There is virtually no shrinkage parallel to the length of a piece of wood. The radial retraction occurs perpendicular to the annual rings. It narrows in the center of the tree.
adj not aged or processed
Stress levels are derived from the visual or mechanical representation that indicates the stress limits that apply to timber used in construction applications. Stress classes are known with classes F (F4 to F34) F14 indicates that the base load for this wood is approximately 14 MPa.
Place a dehumidifier in the center of the room after removing all standing water. Set the extraction setting as high as possible. Turn it on and let it sit for at least 24 hours to absorb the moisture from the boards. Place fans that ■■■■ on the surface to dry the wood.