Shut off the water supply by lifting the float with the tank size lever or by shutting off the water supply to the ice maker. 4. Drain the water from the ice maker by pulling the container drain tube out of the drain and reinsert it into the cap after emptying. Note: Allow to drain into the drip tray on the underside of the device.
Restoration of a Scottish ice maker
- Find the Scotsman Ice Cream Maker Control Panel. Most models have the control panel on the front of the machine in the upper corner.
- Briefly press the red button to turn off the ice maker.
- Press and hold the green button for 1 second to turn the machine back on and reset the ice maker.
Leaking or Too Much Water: Leaks can affect ice production in the device. Check for hot gas leaks, thermal expansion, or water inlet valves. Low Ambient Temperature - Most Scottish ice makers will not make ice if the temperature is below 55 degrees Fahrenheit.
Pour 12 ounces of Scotsman Ice Maker Cleaner into the water in the tank. Return the evaporator lid to its normal position. * The other components must be cleaned and disinfected regularly. The complete procedure can be found on the machine or in the manual.
Since this container is in the freezer, it will be cold and the water will start to freeze. There is a sensor nearby that measures the water temperature and waits for it to reach a certain temperature (usually around 12 ° C / 10 ° F). When this temperature is reached, the water is frozen and can be removed.
Locate the reset button, the red reset button should appear on the underside of the ice maker. To reset the ice cube maker, press and hold this button for 10 seconds. You can let it go sooner if: The ice maker starts making noise and starts working.
about 20 minutes
Now is the time to collect the ice. The remaining excess water is discharged down the drain as the gas heats the evaporator. When the evaporator heats up, the ice cube tray slides into the storage container. For example, suppose the cubes remove the water curtain (or the ice damper), then the machine goes through another freeze cycle.
Cause: A common cause of clogging is frozen water in the pipe. Cause: It is also possible that the ice maker’s water filter is clogged. Solution: Find and replace the water filter. The filters for the ice maker are usually placed in the refrigerator (to prevent freezing).
Most ice makers that require ice cubes require a drain line, but there are exceptions, such as the EdgeStar IB120SS, which don’t. These models act like a freezer and keep ice cream frozen, so there’s no need for a drain hose. Other ice makers cannot keep the ice frozen and when the ice melts it must be emptied.
Ice maker troubleshooting instructions Check the stop lever. Check the supply valve. Check the water supply. Test the stop switch. Check the temperature in the freezer. Check the ejector. Test the ejector motor. Try the ice mold heater.
Probably below the position of the controls. The water in the ice cube tray can be as simple as a clogged drain for an ice cube tray (melting ice). The container is nothing more than a large insulated container, similar to a refrigerator, but with a drain. The ice cube tray has not cooled down.
Remove the ice cube tray, allow it to cool and let the frost melt in the ice cube tray. Open the cap on the bottom of the ice cube tray and let the ice cube tray drain. Promote faster dissolution by pouring hot water into the container. Clean the inside and outside of the ice cube tray with a food detergent.
Ice cube refrigerator too full If the water pressure is too low, the valve may not close completely when it is turned off. If the water pressure is sufficient, the water inlet valve is probably faulty. It is not certain that the valve is fully closed or blocked so that water flows out through the valve.
Although size and capacity are some of the main factors that will affect the overall price, some built-in ice makers will cost more because they have a good brand reputation or have extra features like a water filter or the ability to make nuggets. of ice.