If you can, open the glove box and look inside from above, there is a thin plastic flap at the top, press with moderate pressure as you pull the compartment down and it will fall all the way down.
STEP 1: OPEN THE STORAGE COMPARTMENT TO ACCESS THE CAB AIR FILTER
- Open the glove box and remove the contents.
- Remove the fixing arm from the glove box by sliding the pin.
- Grasp the front and back of the glove box and press down until the entire glove box can be dropped.
Remove the glove box. Disconnect the cable on the left side by sliding the plastic latch back / down into the hole and passing the end of the button through the hole. Fold the latches on each side inward to remove the rear of the dashboard and lower the glove box. Lift the dashboard hinge to unlock it and remove the glove box.
If you can, open the glove box, then look inwards at the top, there is a thin plastic flap at the top, push with moderate pressure and pull the box and it will fall all the way down. Hope it helps.
Sometimes a car in the vehicle is located behind a glove box. Depending on the make and model, a computer is also referred to as an electronic control unit, electronic control unit, or powertrain control module. Whatever the name, this device is the heart of a vehicle’s in-vehicle diagnostic system.
The main purpose of cabin filters, which have been installed in most vehicles since 2000, is to keep the air inside the vehicle clean. It is usually found behind the glove box or under the hood or dashboard of most modern cars.
A glove box or glove box or glove box is a compartment built into a car’s dashboard, which sits above the passenger compartment in front of the front seat and is often used for various storage areas. The name comes from the room’s original purpose for storing car gloves.
Remove the glove box to replace the cabin air filter and / or replace the LED lamp. Squeeze the glove box sideways and lower it. Remove the screw and pull the glove box towards you. The cabin filter is located directly behind it.
Registered. You should get the whole box out. Look at the bottom of the glove box and you should see two pegs, one on each side. Use a flat blade screwdriver to remove the two pins. Then open the glove box as usual.
If the click comes from under the dashboard, the body control module or a faulty actuator for an HVAC mixing door is started.
5 people found this helpful. It’s definitely AC.The vehicle has four actuators and you will usually have to replace all of them.
We currently have two mixed operator products to choose from for your 2013 Chevrolet Impala and our stock prices range from just 36.99 to 46.99.
To remove the glove box: 1. Grasp the left side of the glove box and pull to the right. This will remove the left tab from the vinyl dash, allowing the left side of the box to slide out.
Press both sides of the glove box together (1) and fold the drawer back onto the floor. In each lower corner of the glove box (1), pull the drawer up and towards the seat and remove it from the hinges. Colorado 7 only note: Remove the glove box by tilting it towards you and pulling it upwards.