Check the on / off switch on the inclined trainer frame near the power cord. If the switch protrudes as shown, the switch is activated. To reset the power switch, wait five minutes, then press the switch again.
- Press and hold the button for 15 seconds to reset iFit Link.
- After pressing the button for 15 seconds, release it and your link will turn on all four LEDs, then three, two and one.
NordicTrack Make sure the machine is not on a schedule or moving. Find the reset hole / button under the console. It requires a Qtip or something similar to press the button. When finished, the treadmill will reset itself.
To reset the NordicTrack treadmill, set the switch to OFF. Wait 5 minutes and then turn the switch to ON. To stop the runner, press the stop button. The time begins to appear on the screen. To reset the fabric, press the Start or Speed Increase button.
Weight Capacity The X9i can hold up to 300 pounds, which is fairly standard on NordicTrack treadmills. Folding The X9i is not designed to be folded. Space / Footprint The X9i needs a special place in the house because it doesn’t fold or move easily. Overall, the X9i is 39.6 wide, 70.2 long and 71.6 tall.
Follow the steps below:
Reinstall the iFit Software: Repair Tool
The reset button is located on the left side of the treadmill base when you are in front of the device. It is located on the right side when you are on the treadmill in front of the screen.
Under the hood. Loose or damaged parts under the hood of the treadmill can prevent the machine from starting. If the console is on but the treadmill does not start, the motor controls may be damaged. Loose cables under the hood or in the console can prevent the treadmill from starting.
Age 7 to 12
Insert the safety key correctly when starting the treadmill. If the treadmill does not start with the safety key inserted, unplug the treadmill and check the cable connections between the console screen and the motor control board. Connect any loose wires and repair any damaged wires.
- Disconnect the treadmill from the power supply for at least 30 seconds.
- Remove the safety key and replace the treadmill.
- Press the reset button once so that 10 appears on the display.
- Press Enter four times, then start over and type again.
- Replace the security key.
Check the reset / switch if the power is cut off during use. Wait five minutes, then plug the reset button back in. Check that the power cord is still connected. Unplug the power cord and plug it back in after five minutes. Remove the key from the console and reinsert it to see if the device turns on.
The short answer to this, without going into too much detail about electricity and how it is used by a treadmill, is to ALWAYS unplug the treadmill from the electrical outlet after each use. It can also cause the surge protector to turn the treadmill off and on again during use.
You don’t need an iFit trainer to use the Nordictrack elliptical trainer. It is not necessary - it is just an additional option.
You must first switch to calibration mode on the console. To do this, press and hold the STOP and INCREASE SPEED buttons (this is an up arrow or a + (plus) symbol). While holding these buttons, insert the security key into the console. This will put the machine into calibration mode.
A treadmill can move left or right over time. If it changes enough, the treadmill will no longer be able to move. Stand at the back of the machine and inspect the tape. If it has moved, center it by turning the rear roller fixing screws.