When installing multilayer polycarbonate on a roof, a minimum slope of 5 ° (panel length 9 cm / m) is recommended to allow rainwater to drain.
You can cut small quantities of polycarbonate sheets with a utility knife. Large jobs should be cut with a circular saw, table saw, or jigsaw. In any case, you need a nice bluetooth blade. (Plywood / finishing blade for circular saws / table saws and a metal cutting blade for reciprocating saws.
Polycarbonate does not stick and the glass strips are very easily damaged. I haven’t seen any plans of the kind you mentioned. Scaffolding is widely used, but some means need to be developed to prevent displacement, even the roof may require internal support.
If necessary, use tape at the bottom (needed for the size of the hole, sometimes not required), plumbers and roofers will remove the silicone on the top about 3mm thick. Swipe your finger across the sheet of paper. Remove the tape the next day and the silicone is there. Mesh is not needed and clear silicone is the cheapest solution.
End caps should be used on the underside of the cover plates (closest to the eaves). Available for 10mm, 16mm and 25mm polycarbonate sheets. Make sure that the closure of the polycarbonate sheets is sealed with a silicone with a low modulus of neutral curing (e.g. Soudal LMN silicone, available from us).
Suntuf panels can be cut with a circular saw (with a very thin sheet, for example an Irwin Marathon PVC sheet). Or with a nice puzzle. For best results, it is often best to cut a few sheets of paper at a time to reduce vibration.
It is possible to use metal roofs on such a small slope with a slope of 2 x 12 and a slope of less than 4 x 12. This is known as a low-pitch application and requires additional steps (see roof slope above) . On the one hand, make sure the plate overlaps the bottom plate. Use 36 overlays at the end of the lines.
Polycarbonate is a very strong and resistant thermoplastic material. Polycarbonate is also very light and can withstand extreme temperatures, both hot and cold. These properties make it an effective roofing material for many applications.
Polycarbonate is a strong, lightweight thermoplastic material capable of withstanding extremely high and low temperatures. This durable and practical roofing material is perfect for porches, patios and terraces, but it is not practical to cover the entire roof of a house.
Mounting a polycarbonate roof can give you confidence while enjoying the summer sun. Polycarbonate is a thermoplastic polymer that lets sunlight through but blocks UV rays. It is also practically indestructible.
The polycarbonate lens offers protection from the sun’s harmful UV rays. Polycarbonate lenses block 100% of UV rays. While uncoated plastic sunglasses block about 88% of UV rays. In general, the cheapest sunglasses are made from triacetate, which blocks about 40% of UV rays.
Winter roofs are not designed to be load-bearing. Do not try to stand, walk or crawl in front, winter roofs and panes of glass are not suitable for standing! After cleaning, rinse the roof with a pressure washer or garden hose.
Wash the polycarbonate sheet with mild soap and lukewarm water. Use a soft cloth or sponge and wash gently with an up and down motion in the same direction of the grooves as shown in Fig. 1. Rinse the cloth or sponge and change the water frequently.
No, don’t go directly to the polycarbonate sheets. Polycarbonate sheets are not designed to support a person’s weight. Use ladders or place caterpillars between two or more barriers to create a walkway.