An Intex pool would look good on concrete, you just need some sort of pool mat to install it. The only problem is I can’t see myself leveling the area in any way. However, it is quite easy to put a standard steel wall over the basin on concrete on the floor.
As long as it’s flat and level, a concrete slab is a perfect base for an above ground pool. Homeowners who choose to install one of these pools often place it directly on the floor, but it’s best to place it on a concrete slab.
Kisses of sand. Sand spread over the pool is a traditional method of installing an above ground pool. As with commercial pads, you can use sand alone or place it on concrete. Keep in mind, however, that sand can make your pool unstable if it rests on concrete.
Pools Installed on a Concrete Base A concrete slab is actually a great base for a pool as it is usually completely flat and level, so the pool doesn’t change much. But concrete is a rough surface and will crush the pool liner over time.
Most often, the material is used on the basis of wall sand or rock flour. Wall sand, also known as swimming pool sand, offers a very smooth surface and is the most popular choice.
Gorilla Pads are pre-cut mats that protect and cushion the floor of above ground pools. Unlike older pool foam cushions, which can be easily cut or punctured by grass, roots or stones beneath the surface of the above ground pool, Gorilla Bottom padding is insensitive to almost any sharp object.
Use a spirit level on the string to measure the 1236-point level around the pool. Use shallow shovels or a planter to remove grass and lower high points. Add a 1-inch layer of sand. Wrong direction: increase the lows by adding sand - do not check the level.
Installing an above ground pool on natural lawn is not a good idea, especially if you plan to demolish the pool later in the year. Since natural grass becomes muddy and can be quite slippery when wet, there are also safety concerns and of course where to find mud and wet grass in the house.
A tarpaulin ensures that lumps and bumps on a dirty surface can pass through the bottom of the pool. This makes the floor lumpy and uneven, making cleaning difficult. The sand becomes smoother, making the bottom of the pool easier to clean and easier to walk on.
The average above ground pool lasts 7 to 15 years before the structure collapses. Your foods will last 5 to 9 years before needing to be replaced. With ingrained construction, the lifespan is highly dependent on the type of pool. For example, fiberglass is said to last over 20 years.
We place the pool on a bottom of at least 20 cm of fine sand, which is covered with a foam sheet for additional protection. This should also be leveled to provide the best position for the water. Don’t use the paver base, but you may be able to use pavers to catch sand. You can do this on pebbles or concrete.
How to Empty an Intex Pool
Sand is the recommended base material for an above ground pool. Sand is used under an above ground pool to protect the vinyl siding from stones and objects that could tear the liner. The sand under an above ground pool also acts as a cushion for the bottom and makes it more comfortable for the feet.
Spread a layer of crushed limestone 1 to 2 inches deep over the pool. Wet with a garden hose and press firmly. Use the wooden plank to level the limestone floor. Remove the wooden board and the 2-inch wooden stick.
In general, a concrete pool should be 6 inches thick to be structurally sound. Depending on the engineer and the nature of the terrain, there may be more. (Also, the inside of the plaster must be at least 10 cm thick.)
I use the sand under the Intex pools to moisten the bottom, but not for leveling. You can then simply place a smooth rag on the earth or cover the area with an inch of sand. A 24-foot pool will likely use around 3 tons of sand.
Empty the pool every day
For a 15-foot by 15-foot 225-square-foot pool, you’ll need 38 50-pound bags of sand for every inch of sand for your 225-square-foot area.