To properly drain a washing machine, install a support tube. A piece of vertical pipe is connected to a ptrap, which in turn is connected to the drain. The top edge of the drum tube must protrude beyond the overflow of the washing machine and be well ventilated.
If your washing machine drain fits the drain well, you definitely need a drain valve for your washing machine. Allows air to pass through, preventing the possibility of a vacuum build-up that could interfere with the water flowing out of the washing machine.
The sanitary code limits the length of a tailpiece to 24 inches. The only exception to this rule is the support tube [washing machine drain]. A support tube for an automatic washing machine should be at least 18 inches long, but no longer than 30 inches, including assemblies.
Riser The correct way to drain a washing machine is to install a riser. A piece of vertical pipe is connected to a ptrap, which in turn is connected to the drain. The top edge of the drum tube must protrude beyond the overflow of the washing machine and be well ventilated.
the siphon should be the first water to flow before entering the rest of the piping system. There are ventilation openings in the piping system that support the drainage of water as it enters the P-trap.
The purpose of a trap is to prevent exhaust gases and possible pests from entering the home. Back to S-traps - The reason S-traps are not allowed is because they have the potential to suck or suck water from the siphon as the water flows down the drain.
The washing machine drain hose has an outside diameter of 1¼. (Outer diameter). The drain hose must be at least 30 ° high so that no water forms. For the drain hose to work properly, the drain must be at least 30 cm above the floor and less than 2 meters high.
One of the most common reasons a washing machine overflows is a seal in the drain line. Over time, various things like dirt, lint, and hair can slowly build up in the tube to form a plug that prevents water from draining completely.
If there is a blockage in the drain hose of the washing machine, there is an unpleasant smell that resembles the exhaust gas. Bacteria form on dense organic material like hair and soap and cause a sewage smell when water runs down the drain.
Electrical connections to washers and dryers must be within 6 feet of the unit. Although the minimum height of electrical outlets in a home is highly dependent on local building codes, both outlets should be positioned between 34 and 36 inches tall for simplicity.
Emptying the washing machine
The instructions say: We do not recommend the use of extensions if absolutely necessary, the extension must have the same diameter as the original tube and must not exceed 150 cm. Make sure the end does not drop more than 15cm (6in) when the drain hose is pushed through an extendable hose.
All washing machines require a 2-inch drain hose. The previous requirement of 1 1/2 inch hoses is not enough to cope with the rapid drainage of modern washing machines. As with all ■■■■■■■■ and sanitary ware, the washing machine’s drain hose should also contain a siphon.
A washing machine or dishwasher tub usually consists of a 40mm plastic tube. We always prefer solvent or pressure welded ■■■■■■■■ for the exhaust pipe, as it is glued once and there is no risk of leakage.
The floor and drain pipes run from the toilet, sink, shower, washing machine, urinal, bidet and any device that drains the water and joins the pile on the floor. The pole falls directly into the underground drain. It is especially important to use the right pipes for the dirty water.