To use this HTV vinyl remover, turn the garment upside down and lay it on your back. After the remover has covered the entire back of the iron-on transfer vinyl, leave it on for about a minute.
Place the unwanted iron-on vinyl area on the platen and tighten it with one hand. Use scissors, an XActo knife or razor blade and remove the HTV with a slight swipe motion, starting at the top of the unwanted heat transfer vinyl. The material can fall apart.
You will need to heat the shirt first to loosen the thermal transfer vinyl. If the heat alone isn’t enough or you have glue on your shirt, you can try solvents to remove the rest. I love gone goo, but you can also try acetone (nail polish remover) or alcohol.
AlbaChem Vinyl Letter Remover Solvent completely removes vinyl letters and dirt from most fabrics. The York spout is easy to use and minimizes waste. The highly effective and fast drying Vinyl Letter Remover saves time and money by drastically reducing the number of seconds. treat if necessary.
Put the greaseproof paper over the vinyl letters. If the transfer is vinyl, place the wax paper over the letters and iron it directly onto the wax paper. The vinyl transfer melts and sticks mainly to the wax paper and you can peel the letters off the shirt by peeling off the wax paper.
- Clean and dry the sweater as described on the garment.
- Heat the vinyl letters with a hair dryer until they feel warm.
- Slide the razor blade at an angle to the vinyl letter and gently lift it up until you can pull the letter out with your fingers.
Dampen a cotton ball with acetone or nail polish remover and place a cotton ball on top of the glue. Clean the affected area with a clean cloth. The acetone breaks the glue that the rag absorbs. Continue applying acetone and scrubbing with the rag until all the glue is removed.
Step 1: Dip a cotton ball or the edge of a rag in denatured alcohol. Rub it on the back of the shirt, just behind the iron letter. Wait about 10 seconds and then try to delete the letter. Repeat if necessary.
Test the color fastness of the sweater by applying a small amount of solvent to a small visible area on the underside of the sweater. Dampen a white towel with the solvent and rub it on the back of the number. Make sure you wet the entire area. Don’t worry about overeating the medicine.
Alcohol Rubbing Method
Then place it with the PLASTIC TECH DOWN and the vinyl with the side facing up. It is a layer of plastic that needs to be removed. This is the shiny side. On the other hand, it has the shiny side down.
Weeding vinyl is the process of removing unwanted vinyl from the cutting design. You can think of it like weeding a garden - you carefully dig up all the little pieces that shouldn’t be there without destroying your beautiful flowers.
Heat the ironed letters with a hair dryer. Set the dryer to the hottest setting and turn it on by holding it close to the letters. After a few minutes, the glue on the figures will become malleable, making them easier to remove. If you don’t have a hair dryer, steam the letters with an iron and a damp cloth.
Homemade Glue Removal (like Goo Gone)