How to set a digital health measurement scale O to 0.0. a
- Remove the transport plate from the underside of the balance.
- Set the scale to LBS or KG by turning the switch on the back of the sanitary knife scale.
- Place the scale on a flat surface. Do not rest your weight on rugs or carpets.
- Touch the bottom corner of the bowl with your foot.
- Confirm that the scale is set to 0.0.
The body fat scale uses a method called BIA, or bioelectrical impedance analysis. This is a weak current that flows through the lower body, lean muscles and body fat and calculates an impedance value. The bottom line is your body fat percentage.
The US leader in medical scales Since 1919, Health o meter® Professional has provided the medical community with high quality, innovative, digital and mechanical healthcare. Our scales are designed with healthcare professionals in mind to provide the features that best suit their needs.
Check and make sure that the floor on which the scale will be used is level. If the scale still does not read correctly, it may not be calibrated. To check this, take a known weight and place it on the scale to see what it is reading. If the weight is out of tolerance, the weight may need to be calibrated.
Overview of the most accurate scalesAccuracy stages of product evaluation
|Kinzi precision digital scale||4.3||+/- 0.2 lbs|
|Health o meter® Professional 349KLX digital medical floor scale||4.6||+/- 0.2 lbs|
|Vive precision digital scale||4.6||+/- 0.2 lbs|
|Body weight Etekcity Digital||4.3||+/- 0.2 lbs|
Resetting a HealthOMeter scale Place the HealthOMeter scale on a flat surface. Make sure the ladder is really level. Tap the lower left or right corner of the ladder three times. Later, you will find that the ad appears. Wait a few seconds for the weight to zero and recalibrate.
If you scale to 000.0, this error message is displayed. When E is displayed, pick up the phone and repeat the first restart by pressing the center of the scale.
Step Step Place the weight on a stable and level surface. Place one or two computer mouse pads on the table surface. Place the scale on the mouse pad and turn on the device. Press the zero or tare key on the scale. Check if the balance is in calibration mode.
Replacing the battery in a HealthOMeter HDL83063 digital glass scale Turn the scale on a towel to avoid damaging the glass surface. Press the door down and lift the lid towards the chamber. Insert the new battery into the compartment. Slide the metal tab onto the new battery.
Proceed as follows or consult the operating instructions for your model: Lift the display cover. User 1 starts blinking. HEIGHT and AGE appear on the screen. After entering the length, press the AGE button. MALE and FEMALE images are displayed.
It means low battery.
■■■■ battery or unstable AC power source - ■■■■ batteries are the most common cause of digital scale failure. Your weight will appear slow or inaccurately measured when the battery is low.
Check the surface level. The most common mistake is not placing the scale on the correct surface. Reset the scale. Calibrate the balance. Check the batteries on the scale. Take a quick look at the manual. Check for errors on the display. Seek professional help.
Commercially available 2-volt CR2032 lithium batteries are used in our lithium balances.