How to attach the chain on a Remington 14 "chainsaw
- Disconnect the power cord from the chainsaw.
- Turn the chain tension adjustment screw counterclockwise with a flat blade screwdriver to loosen the chain tension.
- Wearing gloves, pull the chainsaw chain around the guide bar and sprocket.
How to change the saw chain on the Makita 2-stroke chainsaw
- Step 1: Before attaching a new chain to the saw, check if the sprockets are too tired or damaged.
- Step 2: Remove the gear cover.
- Step 3: Remove the chain and bar from the saw.
- Step 4: Remove the lock.
- Step 5: Remove the pressure washer.
- Step 6: Replace the gear cover with a new one.
There is a tensioner at the bottom of the rail on the chainsaw. Turn clockwise to tighten the chain and counterclockwise to loosen it. Do not overtighten the chain or it could break. The Echo video below shows the correct way to adjust the tension on a chain.
The main reason for chain skipping is usually insufficient chain tension. When changing the chain, make sure it works in the correct direction and adjust the tension with the adjusting screw, then tighten the two screws firmly.
Use the tool and the depth gauge file to adjust the height of the depth gauges on the chain. If the depth gauge is too high, the knives will not reach the wood. Release the chain each time you fill the chainsaw with fuel. Keep the chain away from dirt when mowing, otherwise it will quickly get bored.
Reason 1: The most common cause of a chainsaw not cutting properly is a blunt chain. Try sharpening or replacing the chain. If the chain is too tight, the chain may not rotate at the correct speed and the chain may not cut properly.
Loosen the guide nuts and turn the adjusting screw a quarter of a turn to loosen the chain if it is too tight. Loosen the guide nuts and turn the adjusting screw a quarter of a turn to tighten the chain if it is slack. Tighten the spindle nuts securely with the adjustment wrench or socket wrench.
Unfortunately, the chain continues to slide in both directions, but if you pull it back it won’t cut. Keep in mind that while holding the chainsaw, the cutting edge of the bar should be facing towards you and moving from the back of the chainsaw to the front end of the chainsaw.
When replacing a chainsaw The chain teeth are damaged or unevenly worn. Chain tension problems. Smoke rises when cutting. What remains is sawdust instead of large wood chips. The saw feels unbalanced, cuts unevenly, or vibrates during use.
How to change the bicycle chain in eight steps Remove the old chain. First discard the old chain. Clean the cartridge. Now is a good time to clean and inspect the chain and cartridge. Insert the new chain. Calculate the correct length. Cropping. Enter the PIN code. Slide the stick home. Complete.
It is not normal for a chainsaw to smoke, but if it does it could be due to the chainsaw overheating, the fuel mixture with too much oil, or the chain not being sharpened or lubricated enough. In short, a smoking chainsaw is a sure sign that something is wrong.