The combination of wind, sun, freezing temperatures and a lack of water in winter can cause the leaves of the tree of life (as well as the leaves of other conifers) to turn brown. ). This happens because they dry out. Water is the elixir of life for the leaves.
In extreme weather conditions, including strong winds, heavy rain, and ice or snow in colder climates, both upright and ■■■■■ trees of life tend to split apart, with some branches even touching the ground. All you need to do is hold the hanging branches in place.
Cut strips 1 1/2 to 2 inches long from a flat, heavy material, such as burlap. Fold one of the ribbons around the tree, for two thirds of the trunk. Tie one end of a length on both ends of the strip to the line of the fabric. Stretch the clothesline until it is inserted and wrap the free end around the notch and tie it tightly.
When exposing arborvitae roots, they should be light and fresh. If the roots are dark and brittle, they will be damaged and will not function normally. Downy mildew fungus can also cause discoloration at the base of the tree trunk.
Fungal pathogens are the pathogenic organisms that lead to three common tree diseases such as redness. For example, the fungal disease Kabatina thuyae kabatina causes twig fungus, a disease that kills the tops and often entire tree branches.
The trees of life are not to be overcome. Pruning the top of a tree of life stops vertical growth and creates a large, unsightly area with no green needles.
Use your chainsaw to cut the tree of life. The abutment must not protrude more than 15 cm from the ground. If you don’t have a chainsaw to help you with this process, you can use the ax to cut a large wedge into the stump of the tree of life.
How to prune Arborvitae trees
How to prune an overgrown tree of life
Winter damage to Arborvitae
Thuja Green Giant Arborvitae Distance
However, when the branches of the trees of life die in this way, there is nothing you can do to bring them back to life. Your only hope is that there is still life in the branches so that new shoots will appear next spring. Don’t cut what appears to be ■■■■ wood.
Arborvitae tolerates wetter soil than many conifers, but will drown if too wet. In general, with newly planted shrubs, it is important to water more frequently first and then gradually decrease, so that watering every five days or once a week is usually sufficient.
Evergreens don’t always live up to their name. Whether they are conifers or broad-leaved trees, conifers and shrubs can appear sickly and brown in spring, especially after a particularly cold or dry winter. While some grain loss may occur, most brown conifers will return as spring progresses.
On your Arborvitae trees, the vertical shoots of the green parts of the horizontal branches will eventually grow vertically and upward to fill the open area of the Arborvitae, but it will take several seasons to see them. The cut top will stop growing.
Prune the damaged leaf against winter conditions. When the entire branch is brown, scrape the bark off the affected branch and look for the green underneath. Water the tree of life well when it is dry. If the foliage is turning brown from drought, it may be too late to save, so it’s best to prune the ■■■■ foliage.
Both root rot and ear rot cause the leaves of the emerald green tree of life to turn brown. Caused by different types of fungi, but with the same result, infested trees die from these diseases. Prevent lazy diseases by planting emerald green arborvitae in well-drained soil, not surface water.
Remove as much soil as possible from under the exposed roots and gently straighten the tree. It is not possible to repair this type of crooked shaft and the shaft must be removed. Straightening a tree or keeping trees from bending down isn’t easy, but with a little knowledge and a lot of diligence, it can be done.